Torque Calibration NSW - Rad Norbar Hytorc

Torque Calibration

Hydraulic Torque - Square Drive Tools

Battery Nut Runners

Air Nut Runners

Back Up Spanners

Porta Power - jacking rams pumps

Calibration Eqp

Pumps - Hydraulic

Hand Torque Calibration	Torque Multipliers	Nut Runner Calibration	High Torque Calibration	Hex Cassettes

Full Torque Calibration Service NSW & QLD - Sales & Hire. High Torques, Hand torque, Nut Runners, Pressure Gauges. 20 Years Experience - All calibrations offered with full certificates. Its recommended Torque equipment be calibrated minimum 12 monthly to ensure output accuracy. Torque output loss is not visible. All Torque tools are mechanical meaning damage, wear, dirt, water, loss of lubrication, will create toque output loss will result. Calibration frequency ranges from 3 to 12 monthly depending on type of tool, industry and usage. Static method is used for High torques, multipliers and hand wrenches. Dynamic measurement is used for nut runners powered by Air, 240 Volt or battery.

	HAND TORQUE WRENCHES Its important to regularly re calibrate hand torque wrenches because they tend to be over extended and damaged. This mostly occurs because they have no real limiter. Calibrating these tools should be done on a fix bed and triggered mechanically to eliminate human error and variations. Accuracy with these tools may vary in the field depending on the the torque value, and how the user operates to wrench.
	TORQUE NUT RUNNERS ( Stall & Shut Off ) These tools use Air, 240 Volt or Battery motors that drive multiplying gearbox. These tools must be calibrated dynamically ( Soft Joint ) This means the tool is stalled slowly to ensure the readings are free of inertia or momentum. The readings are mostly taken at the torque peak particularly for shut off tools - battery & 240 Volt. To archive accuracy and full output the following should be tested & checked. Gearbox and motor & damage or friction, regulator operation, Oil Drip rate function & setting, Pressure gauge accuracy, CFM Inlet air restrictions, battery condition & charge status. Any issues would require correction to enable authentic calibration outcomes. Note: For air tools,on return if using small entry air fittings or long small diameter hoses you will inhibit cfm. This will in turn reduce torque output. Nut runners should only use their own chart due to variations from tool to tool.
	HYDRAULIC WRENCHES ( Stall Tools ) Sq Drive & Hex Cassette. Hydraulic wrenches are measured statically. This effectively means a hard joint. This is possible as there is no real momentum and these are a stall tool. The Tool Pre checks requited are Hydraulic seals, mechanicals, lubrication levels and its function. The Hydraulic pump requires the correct oil type & levels , pressure gauge accuracy & correct pressures and porting to be tested. For Hex Cassette tools the power head should remain with the intended cassette size to eliminate variations & connection issues.

www.tjtools.com.au

ALSO SEE - Hire & Sales - Industrial Tools

High torques - Sq Drive	Hex Cassette - USA	Battery Torque Nut runners	Air Torque Nut runners	Impact Wrenches

Torque Multipliers	Hand Torque 1/2, 3/4, 1"	Impact / Torque Sockets	Impact Sets	Hex Reducers

Backup Spanners	Ring - Flat /Offset	Flat /Open end	Calibration 10-25,000 Fts	Huck Guns 1/2 to 1-1/8"

Porta Power - Hydraulic	Pumps - Hydraulic - Hand	Pumps - Hydraulic - Air	Pumps - Hydraulic - 240v	Compressors - Diesel

Top of this page